TwinTurbo.NET: Nissan 300ZX forum - I wondered if heat was a factor in using
Subject
I wondered if heat was a factor in using
Posted by
xpwarrior
on April 09, 2015 at 10:41 AM
This message has been viewed
198
times.
In Reply To
4hrs to install "a" camshaft... Gzum
posted by LivinTheDream
on April 08, 2015 at 10:49 PM
Message
silicone on the exhaust cover instead of a rubber gasket. The rubber can get fairly crunchy over time when exposed to a lot of heat. Since that cover sits right above the exhaust or turbo they might have tried to head off possible leaks.
Follow Ups
4hrs to install "a" camshaft... Gzum
-
LivinTheDream
22:49:31 04/08/15
WD-40 & Scotch Brite pads to clean the RTV off the heads
-
vorpalZ
23:42:00 04/08/15
wd-40...duh. thanks.. still tedious (n/m)
-
LivinTheDream
00:01:16 04/09/15
There isn't a large enough groove in the exhaus valve covers
-
MixManMash
07:41:07 04/09/15
A T shaped gasket would work. And yes I do cover but things
-
LivinTheDream
08:32:38 04/09/15
I wondered if heat was a factor in using -
xpwarrior
10:41:44 04/09/15
makes sense (n/m)
-
LJZTT
11:34:31 04/10/15
Cover the head, yellow roloc disk. Clean in minutes. (n/m)
-
Draker (Eugene, OR)
11:42:02 04/10/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.