Subject	A T shaped gasket would work. And yes I do cover but things
Posted by	LivinTheDream on April 09, 2015 at 8:32 AM
	This message has been viewed 188 times.
In Reply To	There isn't a large enough groove in the exhaus valve covers posted by MixManMash on April 09, 2015 at 07:41 AM
Message	can still sit between the paper towels and head and when you pulls the rags it can fall in so still have to be careful of course. When Im working I have it covered all the time pretty much. Only time it was completely uncovered was when I had to torque down the cam. uhhhhh..... I hate those damn bugs... soooo sneaky. "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	4hrs to install "a" camshaft... Gzum - LivinTheDream 22:49:31 04/08/15 WD-40 & Scotch Brite pads to clean the RTV off the heads - vorpalZ 23:42:00 04/08/15 wd-40...duh. thanks.. still tedious (n/m) - LivinTheDream 00:01:16 04/09/15 There isn't a large enough groove in the exhaus valve covers - MixManMash 07:41:07 04/09/15 A T shaped gasket would work. And yes I do cover but things - LivinTheDream 08:32:38 04/09/15 I wondered if heat was a factor in using - xpwarrior 10:41:44 04/09/15 makes sense (n/m) - LJZTT 11:34:31 04/10/15 Cover the head, yellow roloc disk. Clean in minutes. (n/m) - Draker (Eugene, OR) 11:42:02 04/10/15
Post a Followup	You cannot reply to this message because you are not logged in.