Subject	WD-40 & Scotch Brite pads to clean the RTV off the heads
Posted by	vorpalZ on April 08, 2015 at 11:42 PM
	This message has been viewed 229 times.
In Reply To	4hrs to install "a" camshaft... Gzum posted by LivinTheDream on April 08, 2015 at 10:49 PM
Message	Small hardwood dowel sharpened to a rounded point to remove the RTV from the grooves in the valve covers plus finish with the WD-40 & Scotch Brite pads. Cleans everything up in no time... Just did a set this weekend, in fact. Course, it also goes faster with a few other folks doing the cover install...
Follow Ups	4hrs to install "a" camshaft... Gzum - LivinTheDream 22:49:31 04/08/15 WD-40 & Scotch Brite pads to clean the RTV off the heads - vorpalZ 23:42:00 04/08/15 wd-40...duh. thanks.. still tedious (n/m) - LivinTheDream 00:01:16 04/09/15 There isn't a large enough groove in the exhaus valve covers - MixManMash 07:41:07 04/09/15 A T shaped gasket would work. And yes I do cover but things - LivinTheDream 08:32:38 04/09/15 I wondered if heat was a factor in using - xpwarrior 10:41:44 04/09/15 makes sense (n/m) - LJZTT 11:34:31 04/10/15 Cover the head, yellow roloc disk. Clean in minutes. (n/m) - Draker (Eugene, OR) 11:42:02 04/10/15
Post a Followup	You cannot reply to this message because you are not logged in.