TwinTurbo.NET: Nissan 300ZX forum - It's pretty much required for older cars, especially OBD1
People Seeking Info
 
   


     
Subject It's pretty much required for older cars, especially OBD1
     
Posted by BlackholeZ on April 05, 2015 at 3:41 PM
  This message has been viewed 307 times.
     
In Reply To Moving to CA posted by JMartz on April 05, 2015 at 09:07 AM
     
Message Most of the inspections are only visual. Emissions techs are not allowed to disassemble anything looking or testing. I've taken my Z to very by the book shops and they couldn't tell that I don't have EGR. I've also had no trouble being TT swapped. The CA cars have an EGR temp sensor that reports if the EGR is working, but the Federal cars do not. My Z is from Oklahoma and I've had no issue passing smog. It's always easiest to find a shop that's not too picky, but as long as you haven't gone full retard on the build you should be fine. Dual maf is not a problem either.

-Dan
VTC Solenoid Caps and install instructions.


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" - ChristopherTheOne
" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.