Subject	If they are the same as kandyorangez's brakets, then yes
Posted by	itsa300zx on March 31, 2015 at 9:21 PM
	This message has been viewed 283 times.
In Reply To	re: the JBP adapters listed in classies.. posted by Gromit on March 31, 2015 at 08:26 PM
Message	a small amount of material removal of the caliper is require. At the ends of the rotor "arc" where it touchs the rotor and at the bottom of the two caliper bolt hole. I would say about 1/16" to 1/8" max depth of removal. I did mine with a deburing tool and took less than 15 mins each.
Follow Ups	re: the JBP adapters listed in classies.. - Gromit 20:26:21 03/31/15 If they are the same as kandyorangez's brakets, then yes - itsa300zx 21:21:19 03/31/15 These do require a small amount of grinding - jobambo 23:07:13 03/31/15 thanks (n/m) - Gromit 00:36:37 04/01/15
Post a Followup	You cannot reply to this message because you are not logged in.