Subject	Well tower bars aren't really experiencing bending forces
Posted by	BlackholeZ on February 03, 2015 at 1:09 AM
	This message has been viewed 356 times.
In Reply To	Powertrix or carbing strut tower braces? posted by RonZ300 (Socal) on February 02, 2015 at 10:05 PM
Message	They transmit force parallel with the bar keeping the shock towers from getting closer together or further apart. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Powertrix or carbing strut tower braces? - RonZ300 (Socal) 22:05:02 02/02/15 Well tower bars aren't really experiencing bending forces - BlackholeZ 01:09:42 02/03/15 thats true to a point...what happens when you take - RonZ300 (Socal) 18:13:41 02/03/15 Carbing, as for the rear get the Type R. - Bernie (NoVA) 01:55:36 02/03/15 where do you get the type R bar? (n/m) - RonZ300 (Socal) 08:55:58 02/03/15 Ironically I got mine from a PowerTrix group buy years ago. (n/m) - Bernie (NoVA) 00:36:03 02/04/15 are there any front ones that fit with out trimming anything - Davez 20:20:17 02/03/15 You can remove the throttle cover... (n/m) - Bernie (NoVA) 00:14:07 02/04/15 Nearly all front bars require the removal of the - Zeke21 09:31:49 02/04/15
Post a Followup	You cannot reply to this message because you are not logged in.