Subject	Thanks. HF has one just like it
Posted by	ZXoltan on January 03, 2015 at 7:32 AM
	This message has been viewed 372 times.
In Reply To	I use this ball joint/ outer ball joint remover posted by itsa300zx on January 02, 2015 at 09:06 PM
Message	but I couldn't figure out how it would fit on to pull the tie rod. When you thread the bolt in, the opposite end gets closer together.... ?
Follow Ups	Tie rod puller... Will this work? - ZXoltan 20:40:52 01/02/15 I use this ball joint/ outer ball joint remover - itsa300zx 21:06:07 01/02/15 Same here. Have the exact same unit. (n/m) - MixManMash 05:38:27 01/03/15 Thanks. HF has one just like it - ZXoltan 07:32:44 01/03/15 I have the HF one, works great. (n/m) - Woody75 (Denver) 12:38:52 01/06/15 Works fine - buy both sizes. (n/m) - Bernie (NoVA) 00:00:21 01/03/15 Since tie rods are tapered, - Boosted1 06:59:04 01/03/15 huge waste of time - Dane (Houston) 01:15:04 01/04/15 Re: huge waste of time - Bad Fish 09:19:32 01/04/15 Yeah, thanks Dane, but I dont want to cause add'l damage - ZXoltan 09:52:40 01/04/15 $35 is not much and one definitely can't have too many - ZXRider 18:09:32 01/05/15 Yup! (n/m) - Stanky 21:23:12 01/04/15 Hammer? (n/m) - John (MD) 10:03:30 01/05/15
Post a Followup	You cannot reply to this message because you are not logged in.