Subject	My experience with ITM Lifters...
Posted by	tiale11 on January 03, 2015 at 12:47 AM
	This message has been viewed 393 times.
In Reply To	Aftermarket lifters posted by EngineerLV on January 01, 2015 at 10:58 PM
Message	In my new ITM set, 2 of the lifters had small dents on top, another one had an outer diameter that was too large thus making it hard to fit and slide inside the buckets, and a few had a the cap improperly installed from the manufacture causing valves to not fully close (see the link below). I fixed all these problems and they run good for now (only 300 miles on them as of now) La-Z-Link ... In other words, make sure that you check them thoroughly before you pop them in, if you go that route
Follow Ups	Aftermarket lifters - EngineerLV 22:58:45 01/01/15 Well a friend of mine have a Cosworth that he bought - kickerzx 12:33:10 01/02/15 Re: Well a friend of mine have a Cosworth that he bought - EngineerLV 16:29:49 01/02/15 agreed (n/m) - ali300zx 21:20:17 01/02/15 No my phone (Sony) is probably made in China - kickerzx 13:38:55 01/03/15 That said.... If yo CAN find good products.... - kickerzx 13:45:34 01/03/15 Re: Aftermarket lifters - ouikikazz 12:50:52 01/02/15 Am I reading that right - -Grimm- 18:07:35 01/02/15 Yes, so end up costing just over $100 plus shipping (n/m) - ZXoltan 07:35:14 01/03/15 Re: Re: Aftermarket lifters - MLPS300ZX 19:25:55 01/04/15 Re: Aftermarket lifters - EngineerLV 19:39:49 01/02/15 I have the ITM lifters - SammybTT(TN) 20:20:11 01/02/15 My experience with ITM Lifters... - tiale11 00:47:23 01/03/15
Post a Followup	You cannot reply to this message because you are not logged in.