Subject	At 50.5 inches between max rubber block locations,
Posted by	not4resaleZ on December 22, 2014 at 9:09 PM
	This message has been viewed 558 times.
In Reply To	Seems like a great option posted by bartz32tt on December 22, 2014 at 12:58 PM
Message	it looks like you could use the back lift points and get pretty close to the front lift point. On the other hand, if you have lift blocks with a notch cut in them for the pinch weld, looks like the service manual allows lift points there if two are used per side. [ http://www.300zx.co.uk/cgi-bin/manual.cgi?list=gi&dir=&config=&refresh=&direction=forward&scale=0&cycle=off&slide=23&design=default&total=25 ] I think they are trying to keep people from lifting at one point on the pinch weld, say right behind the front tire. This could create too much stress.
Follow Ups	Bendpak Ranger QuickJack 5000 with Z32 - Cherry3z 10:26:04 12/22/14 Nice (n/m) - Frldy_Z 10:33:03 12/22/14 Re: Bendpak Ranger QuickJack 5000 with Z32 - KA8 11:05:35 12/22/14 Re: Re: Bendpak Ranger QuickJack 5000 with Z32 - ouikikazz 12:58:43 12/22/14 It has a safety bar, though one bolt is all that holds it. (n/m) - Ted (92TT) 16:09:38 12/22/14 Re: It has a safety bar, though one bolt is all that holds it. - Cherry3z 16:46:59 12/22/14 I'd keep those jack stands or "nixit" blocks as well (n/m) - BoneZ (MD) 13:37:19 12/22/14 If you don't mind, more pics would be helpful. - bartz32tt 11:43:13 12/22/14 Here is a post i made a while back. Its the 3500 but you get - kickerzx 12:26:06 12/22/14 Seems like a great option - bartz32tt 12:58:11 12/22/14 Re: Seems like a great option - Cherry3z 16:44:39 12/22/14 At 50.5 inches between max rubber block locations, - not4resaleZ 21:09:36 12/22/14 Cool, never knew that. Now I really want one (n/m) - bartz32tt 21:30:34 12/22/14 scissor lift is similar. I've seen them push out the fender - Zbullet 22:38:03 12/22/14 The rubber blocks w/ slit cut in it still pushed - bartz32tt 11:10:45 12/23/14 definatly buying this after xmas!!! (n/m) - mizzuh 14:15:50 12/22/14 Re: Bendpak Ranger QuickJack 5000 with Z32 - diamond20601 16:45:49 12/22/14 Re: Re: Bendpak Ranger QuickJack 5000 with Z32 - Cherry3z 16:50:25 12/22/14 Re: Bendpak Ranger QuickJack 5000 with Z32 - diamond20601 16:50:22 12/22/14 This is great!!!....Time to reload the cash cannon (n/m) - RobZ32 20:16:21 12/22/14
Post a Followup	You cannot reply to this message because you are not logged in.