Subject	I'm not sure how you'd damage an oil cooler by flushing it
Posted by	BlackholeZ on December 08, 2014 at 7:36 PM
	This message has been viewed 298 times.
In Reply To	Oil Cooler Topic posted by FrozTTy on December 08, 2014 at 09:27 AM
Message	I'd maybe run some kerosene or mineral spirits through it. If it's just been open to the air I'd go both directions. Then clean oil to flush the thinner. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Oil Cooler Topic - FrozTTy 09:27:06 12/08/14 Re: Oil Cooler Topic - shaggee 10:01:07 12/08/14 Don't need a larger unit - FrozTTy 10:14:45 12/08/14 Re: Don't need a larger unit - mizzuh 10:21:22 12/08/14 Thanks, did you also use compressed air when you ran - FrozTTy 10:27:29 12/08/14 Re: Thanks, did you also use compressed air when you ran - mizzuh 18:02:49 12/08/14 What would ultimately be best is..... - FrozTTy 13:30:29 12/08/14 Re: What would ultimately be best is..... - plusdaddy 22:16:23 12/08/14 Yea, who would have thought putting engine parts - FrozTTy 07:54:27 12/09/14 Just upgrade your oil cooler or leave it as is. (n/m) - ForceFedTT (SoCal) 17:36:52 12/08/14 guess i should have mentioned..... - FrozTTy 18:03:56 12/08/14 I'm not sure how you'd damage an oil cooler by flushing it - BlackholeZ 19:36:23 12/08/14 2nd. Biggest risk is additional contaminants trapped that - ZXoltan 16:58:28 12/09/14 Not a bad idea - BlackholeZ 00:38:21 12/10/14 I cleaned mine doing... - tiale11 15:02:12 12/09/14
Post a Followup	You cannot reply to this message because you are not logged in.