Subject	bushings.....not one of the most fun jobs, but one of the
Posted by	TTZ2NV(EPTmotorsports) on December 07, 2014 at 4:22 AM
	This message has been viewed 361 times.
In Reply To	Replaced my rear bearings, ball joints, and Bushings! posted by iceman601 on December 06, 2014 at 03:13 AM
Message	Most rewarding........good stuff dude!!!!!
Follow Ups	Replaced my rear bearings, ball joints, and Bushings! - iceman601 03:13:44 12/06/14 "Fat Tire"... nice touch ;-) - ZXoltan 07:29:58 12/06/14 Have you noticed any difference in the ride? (n/m) - phillyz 10:32:24 12/06/14 Yes, right off the bat....but wouldn't say it is stiff - iceman601 11:37:15 12/06/14 how much did everything run you on this job? time? (n/m) - dTb 13:43:11 12/06/14 It was on stands for a week - iceman601 14:50:15 12/06/14 Not too bad. Now you have a press which will more than pay - dTb 15:25:14 12/06/14 Made a cool spinning table with old hubs and bearings - iceman601 14:55:23 12/06/14 Perfect candidate for a cracked wheel. (n/m) - BlackholeZ 16:10:06 12/06/14 going to do the same with one of my SSR's .. tits (n/m) - genic 20:47:38 12/07/14 bushings.....not one of the most fun jobs, but one of the - TTZ2NV(EPTmotorsports) 04:22:12 12/07/14 looks good. also, which ball joints did you use? (n/m) - slayer fan 14:18:25 12/07/14 picked up Masterpro Sentra ball joints due to time. (n/m) - iceman601 19:15:25 12/07/14
Post a Followup	You cannot reply to this message because you are not logged in.