Subject	Re: jim wolf technology ecu??
Posted by	mizzuh on December 06, 2014 at 9:12 PM
	This message has been viewed 329 times.
In Reply To	jim wolf technology ecu?? posted by jhop1988 on December 06, 2014 at 09:05 PM
Message	im trying to decipher your message, but what i think you are saying is "I have purchased a new motor, and it came with a JWT ECU" now I think you are asking "do I need to do anything special to run this ECU" the answer is no. you can plug it up, and run it, as long as you have the modifications that are specified on the new "chip" that is in your JWT tuned ECU. if you do not know what chip is in your ECU, you will have to open it up, get the numbers off of the chip, and call JWT and ask. more than likely it is a POP charger, and a better fuel map with higher rev's and speed limiter removed. good luck (and please take your time and use punctuation, it is hard to figure out what you are asking)
Follow Ups	jim wolf technology ecu?? - jhop1988 21:05:16 12/06/14 Re: jim wolf technology ecu?? - mizzuh 21:12:05 12/06/14 Please contact JWT - they are your best resource on what you - Bernie (NoVA) 22:20:01 12/06/14 as will have to make sure your timing set to 15 degrees, and - TTZ2NV(EPTmotorsports) 04:12:17 12/07/14 Re: as will have to make sure your timing set to 15 degrees, and - jhop1988 12:53:23 12/07/14 *and, not an (n/m) - vulcanrush 16:35:39 12/07/14 You need someone (JWT to otherwise) to confirm the program - spicyZ 09:14:35 12/08/14
Post a Followup	You cannot reply to this message because you are not logged in.