Subject	I think your friend was talking about a different type of hu
Posted by	BlackholeZ on December 05, 2014 at 8:31 PM
	This message has been viewed 487 times.
In Reply To	I know what you mean. I threw the idea back and forth. posted by zQuikonE on December 05, 2014 at 03:59 PM
Message	There's no "wear" between the hub and bearings. If someone got new bearings and they died immediately it's because someone installed them wrong. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Replaced my rear bearings and wheel hubs! - zQuikonE 15:11:50 12/05/14 Cool, but I see no reason to replace the hubs. (n/m) - Bernie (NoVA) 15:38:18 12/05/14 I know what you mean. I threw the idea back and forth. - zQuikonE 15:59:34 12/05/14 I think your friend was talking about a different type of hu - BlackholeZ 20:31:50 12/05/14 I was thinking a long those lines when I stared at it but - zQuikonE 23:51:52 12/05/14 What bearings and hubs did you go with. If i remember - Hydrus (Dallas) 15:39:31 12/05/14 I used Timken bearings and OEM hubs. - zQuikonE 16:00:32 12/05/14 Correct. There are no aftermarket alternatives for TT's - ZXoltan 19:28:07 12/05/14 Nice fix (n/m) - Whip 16:18:50 12/05/14
Post a Followup	You cannot reply to this message because you are not logged in.