Subject	I think the point is that the whiteline bushings replace
Posted by	BlackholeZ on November 28, 2014 at 2:42 PM
	This message has been viewed 402 times.
In Reply To	Problem is that the OEM FUCAs wear out after time as well. posted by MixManMash on November 28, 2014 at 01:37 PM
Message	the OEM bushings that wear out. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Best adjustable FUCAs? - evan_aggie 07:42:29 11/27/14 Stillen arm has its own issues - LJZTT 10:39:10 11/27/14 That's the old design. (n/m) - ali300zx 11:00:23 11/27/14 roger - LJZTT 20:55:35 11/27/14 Re: Best adjustable FUCAs? - ttz'in (NorCal) 13:12:36 11/27/14 UAS - Still available apparently: - MixManMash 13:47:51 11/27/14 yes, always available direct. (n/m) - lidz 14:14:26 11/27/14 probably these.expensive though. - slayer fan 21:11:12 11/27/14 Nope. UAS is the best. (n/m) - MixManMash 06:41:56 11/28/14 anything wrong with z1? (n/m) - evan_aggie 09:00:12 11/28/14 Not sure, but I wouldn't trust anything they put out. - MixManMash 13:38:40 11/28/14 This would be a much better statement - VERTTZ 10:05:49 11/28/14 I's a bearing design that also pivots axially. (n/m) - Ted (92TT) 11:11:12 11/28/14 it allows travel on the third axis that others don't - vorpalZ 11:22:00 11/28/14 I figured Z1 was alright bc it had bushings too? (n/m) - evan_aggie 11:25:14 11/28/14 There are Two Versions of the Z1 FUCA - flashstar 12:12:02 11/28/14 If you only need a little bit of one-time adjustability, - black300zx 12:04:03 11/28/14 Problem is that the OEM FUCAs wear out after time as well. - MixManMash 13:37:31 11/28/14 I think the point is that the whiteline bushings replace - BlackholeZ 14:42:01 11/28/14 The worn OEM bushings get replaced with the kit. Or are you - black300zx 23:07:52 11/29/14 You have a link? - BlackholeZ 14:45:02 11/28/14 I've been looking at these too. - Polish 15:15:01 11/28/14 Thanks - BlackholeZ 17:12:53 11/28/14 Sorry, I thought it was obvious about the rotation. - MixManMash 13:39:40 11/28/14 Inherent design fault in this type of FUCA..... - zx299 17:58:40 11/29/14 This. I started noticing play in mine and no amount of - MixManMash 21:54:13 11/29/14
Post a Followup	You cannot reply to this message because you are not logged in.