TwinTurbo.NET: Nissan 300ZX forum - I'm curious if there's a controller to dual in wattage
Subject
I'm curious if there's a controller to dual in wattage
Posted by
Jkova300z
on November 12, 2014 at 11:07 AM
This message has been viewed
321
times.
In Reply To
I had that issue long ago. I solved it with the different
posted by Musashi Sword
on November 12, 2014 at 10:52 AM
Message
Of the LEDs to equal or convert it to the 39 watts total to read ok. Obviously 13 watt equivalent LEDs would each put out way too much light.
Follow Ups
3rd brake light led conversion and the dash warning light?
-
Jkova300z
10:38:45 11/12/14
I had that issue long ago. I solved it with the different
-
Musashi Sword
10:52:01 11/12/14
I'm curious if there's a controller to dual in wattage -
Jkova300z
11:07:31 11/12/14
*dial (n/m)
-
Jkova300z
11:08:55 11/12/14
you would have other concerns besides brightness
-
-Grimm-
11:59:28 11/12/14
Actually had similar discussion w IT guy at work
-
Jkova300z
14:27:34 11/12/14
you can get 1% or .1% resistors (n/m)
-
cassi8u99
14:32:08 11/12/14
5% load resistor resistor would be fine (n/m)
-
-Grimm-
14:49:43 11/12/14
Now that I think about it, my problem was going to a
-
Musashi Sword
12:53:25 11/12/14
You can just wire around the module and install whatever
-
xpwarrior
12:55:02 11/12/14
You guys know you can only disconnect ONE wire
-
kickerzx
13:09:14 11/12/14
2nd, or just pull the bulb out. Easily reversible if need-be (n/m)
-
bartz32tt
15:24:40 11/12/14
My OCD wouldn't allow that. (n/m)
-
xpwarrior
15:47:42 11/12/14
LOL (n/m)
-
zgene4
16:03:54 11/12/14
Ok. About bypassing or disconnecting the wire
-
Jkova300z
14:11:06 11/12/14
Post a
Followup
You cannot reply to this message because you are not
logged in
.