Subject	Yeah and I've got the ford mounts too.
Posted by	BlackholeZ on November 07, 2014 at 3:23 PM
	This message has been viewed 382 times.
In Reply To	The studs extend about 1" out on either end posted by -Grimm- on November 07, 2014 at 03:10 PM
Message	I've done similar things on other vehicles (that's how you do headgaskets on 6.4 Fords without pulling the cab) I wonder what's less fun, dremeling next to the engine or pulling the mount... -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Pulling engine mounts with engine in - BlackholeZ 14:31:42 11/07/14 The studs extend about 1" out on either end - -Grimm- 15:10:10 11/07/14 Yeah and I've got the ford mounts too. - BlackholeZ 15:23:27 11/07/14 I don't wish that job on anyone. - bartz32tt 16:01:25 11/07/14 Did a high pressure fuel injection pump on a 6.4 - John (MD) 08:27:05 11/09/14
Post a Followup	You cannot reply to this message because you are not logged in.