Subject	Pulling engine mounts with engine in
Posted by	BlackholeZ on November 07, 2014 at 2:31 PM
	This message has been viewed 443 times.
Message	I'm gearing up to install planar inlet pipes on my Z and totally looking forward to modding the engine mount with the engine in. How crazy am I to consider just pulling the whole mount out and doing the mod outside the car? Possible? I'd love to get the BDE mounts but I don't know if I can stretch my budget that far. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Pulling engine mounts with engine in - BlackholeZ 14:31:42 11/07/14 The studs extend about 1" out on either end - -Grimm- 15:10:10 11/07/14 Yeah and I've got the ford mounts too. - BlackholeZ 15:23:27 11/07/14 I don't wish that job on anyone. - bartz32tt 16:01:25 11/07/14 Did a high pressure fuel injection pump on a 6.4 - John (MD) 08:27:05 11/09/14
Post a Followup	You cannot reply to this message because you are not logged in.