Subject	Not that I will admit to!
Posted by	-Grimm- on September 28, 2014 at 7:34 PM
	This message has been viewed 252 times.
In Reply To	Water Nipple block off? posted by Madhatter10-6 on September 28, 2014 at 05:16 PM
Message	On my NA, when I did the coolant bypass I cut a small section of 5/16" hose, found a 1" long bolt that would thread (tightly) into the hose, covered the threads with RTV and threaded it in. Then I installed that with hose clamps (one on the bolt, one on the coolant nipple) to block off the flow. The correct way to do it is to have it welded. It isnt difficult. ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Est. 400 HP) 1990 300ZX TT 5 Sp (Est. 600 HP) 2004 G35 Sport 6MT (DD)
Follow Ups	Water Nipple block off? - Madhatter10-6 17:16:40 09/28/14 Not that I will admit to! - -Grimm- 19:34:51 09/28/14 I hate that this is the most reliable solution... - Antihero 08:25:20 09/29/14 Fill the caps with rtv before installing. Works like a charm (n/m) - TriniTT 20:33:14 09/28/14 What are you trying to block off? - ZXRider 13:22:00 09/29/14
Post a Followup	You cannot reply to this message because you are not logged in.