TwinTurbo.NET: Nissan 300ZX forum - A response from Nistune (map or nistune for e85..hmm)
People Seeking Info
 
   


     
Subject A response from Nistune (map or nistune for e85..hmm)
     
Posted by wickdGSXR on September 25, 2014 at 11:22 PM
  This message has been viewed 288 times.
     
In Reply To Re: can Nistune autosense the e85 and switch maps? posted by Z ONLY1 on September 24, 2014 at 09:35 AM
     
Message Hi Chuck

I’ve copied Greg on this email. I’m not sure what is meant by not enough resolution and which maps it pertains to

The maps in the latest flex fuel firmware in Nistune now have full 16 load x16 RPM cells for fuel and timing flex control which is better than some aftermarket systems with regards to content adjustment over the entire map

The flex input has a 0-100% ethanol content range which can be scaled against the maps in 3% increments (using scale 0-31) using the fuel and timing content scalers, which should be sufficient. I can always increase this range in the firmware using lower increments if required but did not think it necessary.

If there is any issue with resolution I can always increase it if necessary but so far we have found it to be sufficient during testing

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.