Subject	I'm kinda in the process but intended for a one off.
Posted by	ZILVER-NZ on September 23, 2014 at 8:57 PM
	This message has been viewed 265 times.
In Reply To	This would be VERY hard to design posted by VERTTZ on September 23, 2014 at 02:25 PM
Message	I've made a 300zx txt back lit panel similar to the cup holder design. But instead of the cup hole I made a rectangular opening for a small HKS EVC V boost controller (interface piece). Anyway the stock ash tray cover I believe can be made to close over my plate design, and I'm about to CAD / digitally fabricate a new hinge and bowl housing to make this work. I'll post some photos once I get this done.
Follow Ups	Not a perfect solution to the cupholder - - ZiNnYc 12:30:36 09/23/14 i want a blank cover that can be put there, and still have - genic 12:34:41 09/23/14 2nd, that I would buy. (n/m) - BannonZ 13:43:30 09/23/14 This would be VERY hard to design - VERTTZ 14:25:37 09/23/14 I'm kinda in the process but intended for a one off. - ZILVER-NZ 20:57:27 09/23/14 please do, and please keep me in the loop. i would be - genic 10:34:45 09/24/14 take the cup-holder COMPLETELY out .. just a blank slate - genic 10:33:23 09/24/14 At first I wasn't a fan, and then I was like - VERTTZ 14:20:56 09/23/14 Yes Indeed.. (n/m) - ttz'in (NorCal) 14:35:41 09/23/14 Nice! - L£AÐZX 14:41:43 09/23/14 where did you buy it? (n/m) - slayer fan 17:22:49 09/23/14 But will it hold my Large Double Double? (n/m) - fuzzymonkey 17:27:46 09/23/14 Here is with a 12 oz can and 16 oz coffee - VERTTZ 17:38:04 09/23/14 #like #want #looksgood #slickrick #nodrip #holdmydrink - fuzzymonkey 17:52:04 09/23/14 Dont think it has Big Gulp capacity :-O (n/m) - ZXoltan 20:12:37 09/23/14 Pfffft....automatic..... - Agent X 06:54:15 09/24/14 Bottle of water fits best tucked in where you fasten - FrozTTy 07:29:09 09/24/14 I've started using that spot too - Agent X 09:26:27 09/24/14 Yup and short throw makes it even worse :-( - spicyZ 08:13:04 09/24/14 It is difficult but definitely possible. - VERTTZ 10:51:21 09/24/14 I'm afraid of it spilling! Here's an idea.. - Justin (Bayonne, NJ) 14:43:08 09/24/14 Recycle - Reuse - Repurpose - BoneZ (MD) 23:03:20 09/24/14
Post a Followup	You cannot reply to this message because you are not logged in.