Subject	Sounds Fun!
Posted by	96300NAZ on September 19, 2014 at 12:23 PM
	This message has been viewed 179 times.
In Reply To	300zx OEM tape deck gutted + arduino + Haltec posted by Jiro on September 19, 2014 at 02:57 AM
Message	I want to do a BeagleBone + 7" Touchscreen + Haltech ECU and communicate via CAN bus. The goal is to make a simplistic sensor readouts similar to the R34 setup + media, etc.
Follow Ups	300zx OEM tape deck gutted + arduino + Haltec - Jiro 02:57:27 09/19/14 Anything is possible with time and money - Red Hawk (CO) 03:28:10 09/19/14 Raspberry Pi (n/m) - spicyZ 08:30:09 09/19/14 What about tunes? - BoneZ (MD) 06:42:24 09/19/14 Sounds Fun! - 96300NAZ 12:23:20 09/19/14 I did that... - kenecchi 01:12:27 09/21/14
Post a Followup	You cannot reply to this message because you are not logged in.