Subject	Use an easyout
Posted by	BlackholeZ on September 15, 2014 at 7:48 PM
	This message has been viewed 248 times.
In Reply To	Damn.... I snapped the oem oil line fitting off on posted by Evan(CA) on September 15, 2014 at 07:45 PM
Message	Get one that will fit in the existing hole and you won't have to drill. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Damn.... I snapped the oem oil line fitting off on - Evan(CA) 19:45:15 09/15/14 Use an easyout - BlackholeZ 19:48:36 09/15/14 why do you have the motor out? mods? (n/m) - wickdGSXR 09:23:50 09/16/14 Yup, . - Evan(CA) 20:28:15 09/16/14 Re: Yup, . - wickdGSXR 23:34:57 09/16/14
Post a Followup	You cannot reply to this message because you are not logged in.