TwinTurbo.NET: Nissan 300ZX forum - "I don't know that much about cars"
People Seeking Info
 
   


     
Subject "I don't know that much about cars"
     
Posted by spicyZ on September 15, 2014 at 8:39 AM
  This message has been viewed 240 times.
     
In Reply To Is it hard to swap a engine ? posted by Devonz32 on September 14, 2014 at 11:57 PM
     
Message Have you done anything mechanical related before? Changed your oil? Safely lifted the car?

If the answer is no to those questions, then you'll be WAY in over your head in attempting an engine pull as your first car related activity.

Also, you don't just slap an undocumented JDM engine into your car - it would be a fools errand. It would need at least a 60K job (timing belt, water pump, seals, etc) and more than likely a new oil pan (since most JDM engines come with a dented pan.

More research needed before you end up in a situation where a previously running car gets sold (or worse) parted out since you can't get it back together.

-jb

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.