Subject	Yes, its heavy, but can be done
Posted by	ZXoltan on September 07, 2014 at 6:10 PM
	This message has been viewed 233 times.
In Reply To	Rotated, how difficult? Could you do this by yourself? (n/m) posted by Tanley on September 07, 2014 at 05:22 PM
Message	Make sure you get a heavy duty engine stand, not the super-cheapie. The smaller one will hold the weight, but its not as sturdy. Also, it helps to grab the engine itself, and take some of the weight off the pivot of the stand as you turn it. [You'll have a really hard time if you try to just rotate the bar in back]
Follow Ups	vg weight - Dane (Houston) 22:06:32 09/06/14 see nothing (n/m) - LivinTheDream 22:36:26 09/06/14 Re: vg weight - Dane (Houston) 23:31:26 09/06/14 so if it was fully loaded - Halo TTZ 01:09:30 09/07/14 Hmmmm, that's odd.... - 300ZMang 09:28:32 09/07/14 they dont weight that stuff (n/m) - Dane (Houston) 22:47:54 09/07/14 Ok good, was hoping that! Keep up the good work (n/m) - 300ZMang 08:01:34 09/08/14 Has anyone flipped the fully assembled engine; long block, - Tanley 16:07:47 09/07/14 Flipped as in rotated or as in accidentally dumped it over? - ZXoltan 17:14:17 09/07/14 Rotated, how difficult? Could you do this by yourself? (n/m) - Tanley 17:22:07 09/07/14 Yes, its heavy, but can be done - ZXoltan 18:10:51 09/07/14 Yeah I just grab it from the front of the heads and flip it - -Grimm- 18:45:27 09/07/14 Thanks for the info. (n/m) - Tanley 18:48:39 09/07/14 It's not a good idea to invert the lifters or any used motor - Bernie (NoVA) 20:09:56 09/07/14 I have, that's how I changed my rod bearings last winter - Zvil (FL) 21:56:45 09/07/14 Have you run it since then? - bartz32tt 12:30:40 09/08/14 I put about 18k miles on it since - Zvil (FL) 21:03:54 09/08/14 no adverse effects - aliaZ 15:41:13 09/10/14 Re: vg weight - BLACKBEAST 18:36:31 09/07/14 Hicas solenoid, lines all the way to rear 13.5 lbs - wickdGSXR 17:10:08 09/08/14
Post a Followup	You cannot reply to this message because you are not logged in.