Subject	What remains to be seen is the width. You are
Posted by	JMartz on September 04, 2014 at 8:34 AM
	This message has been viewed 200 times.
In Reply To	Re: Pull the engine? posted by induetime on September 03, 2014 at 05:08 PM
Message	correct in that modification to the crossmember to mount the rack, and yes, the motor can be hung from the shock towers with a wooden cross piece or a motor crane. The Honda rack is thicker where the motor is. Either an eat-out on the crossmemeber has to be cut or the whole rack has to be risen to accommodate the blob. Unsure if there is room above under the radiator support for this.
Follow Ups	Potential Candidates for EPS - JMartz 12:15:41 09/02/14 Hope they have enough juice to not only manage Z32-size - LJZTT 12:31:31 09/02/14 Ehh... mass isn't really consequential here. - Antihero 12:51:08 09/02/14 ok, but the point is there may be some considerations beyond - LJZTT 20:11:49 09/02/14 Here is the RX8 EPS rack... - JMartz 18:51:18 09/02/14 Nice find. - Antihero 19:06:07 09/02/14 Simplicity may be what we need for an adaptation, - JMartz 07:26:49 09/03/14 Nice Rack! - ZXoltan 09:51:37 09/03/14 Simply wonderful! (n/m) - JMartz 10:02:58 09/03/14 Re: Potential Candidates for EPS - induetime 10:42:57 09/03/14 Pull the engine? (n/m) - JMartz 14:10:51 09/03/14 Re: Pull the engine? - induetime 17:08:10 09/03/14 What remains to be seen is the width. You are - JMartz 08:34:53 09/04/14 Correction, the steering rack-and-pinion assembly - JMartz 10:51:13 09/04/14 Any thing is possible... - induetime 11:43:16 09/05/14 3rd gen MR2 epsp has built in reservoir and the ecu to - TTZ2NV(EPTmotorsports) 02:33:17 09/04/14 3rd Gen MR2 pump installation in a 6th Gen Civic - JMartz 10:34:40 09/04/14 Link below shows a speed signal input but likely - JMartz 10:44:24 09/04/14 Lock-to-lock - JMartz 13:09:23 09/04/14 how about the mini cooper EHPS pump - Zbullet 16:18:54 09/05/14
Post a Followup	You cannot reply to this message because you are not logged in.