Subject	Re: ASP is not milled out like the UR. AMS is junk.
Posted by	agent4573 on August 27, 2014 at 3:11 PM
	This message has been viewed 219 times.
In Reply To	ASP is not milled out like the UR. AMS is junk. (n/m) posted by Bernie (NoVA) on August 27, 2014 at 02:18 PM
Message	Any chance you have a picture? I can find the one on IPP's website, and one or two on nicoclub with the pulley already installed on a car. Its hard to tell how the center support is constructed. Since AMS, Stillen, UR, etc all run basically the same design, I assumed ASP did is similarly. If ASP is built in a way that I can part off two of the belt sections and not just the little end one, I could easily be convinced to drop the money on it.
Follow Ups	Does anyone make a single crank pulley? - agent4573 12:44:32 08/26/14 If you have an aftermarket undamped pulley - -Grimm- 14:48:47 08/26/14 Re: If you have an aftermarket undamped pulley - agent4573 15:08:37 08/26/14 Ah I see what you mean - -Grimm- 16:05:08 08/26/14 Re: Ah I see what you mean - agent4573 16:44:02 08/26/14 The ASP pulley is milled from a solid block, sold @ IPP (n/m) - Bernie (NoVA) 02:16:41 08/27/14 Re: The ASP pulley is milled from a solid block, sold @ IPP - agent4573 11:45:59 08/27/14 ASP is not milled out like the UR. AMS is junk. (n/m) - Bernie (NoVA) 14:18:44 08/27/14 Re: ASP is not milled out like the UR. AMS is junk. - agent4573 15:11:54 08/27/14 Re: Re: ASP is not milled out like the UR. AMS is junk. - agent4573 15:28:05 08/27/14 AMS? Sure! what could go wrong? - Antihero 15:48:49 08/28/14 hahahahahahaha! - BlackholeZ 22:01:03 08/26/14 Re: hahahahahahaha! - agent4573 11:42:35 08/27/14
Post a Followup	You cannot reply to this message because you are not logged in.