Subject	Re: hahahahahahaha!
Posted by	agent4573 on August 27, 2014 at 11:42 AM
	This message has been viewed 221 times.
In Reply To	hahahahahahaha! posted by BlackholeZ on August 26, 2014 at 10:01 PM
Message	Yeah. I was holding an aluminum rod in the center to catch it so it didn't hit the lathe as it parted, and all of a sudden the outter rings pops off and bounces around the tool holder. We both kind of looked at each other and instantly realized what we just did. I actually took it over my friends house because when I looked at it, I realized my lathe wasn't going to be big enough to part through the thick center section. When I got there, we chucked it up, and basicaly said, "Oh, its really thin right here, we can part it off without any problems."
Follow Ups	Does anyone make a single crank pulley? - agent4573 12:44:32 08/26/14 If you have an aftermarket undamped pulley - -Grimm- 14:48:47 08/26/14 Re: If you have an aftermarket undamped pulley - agent4573 15:08:37 08/26/14 Ah I see what you mean - -Grimm- 16:05:08 08/26/14 Re: Ah I see what you mean - agent4573 16:44:02 08/26/14 The ASP pulley is milled from a solid block, sold @ IPP (n/m) - Bernie (NoVA) 02:16:41 08/27/14 Re: The ASP pulley is milled from a solid block, sold @ IPP - agent4573 11:45:59 08/27/14 ASP is not milled out like the UR. AMS is junk. (n/m) - Bernie (NoVA) 14:18:44 08/27/14 Re: ASP is not milled out like the UR. AMS is junk. - agent4573 15:11:54 08/27/14 Re: Re: ASP is not milled out like the UR. AMS is junk. - agent4573 15:28:05 08/27/14 AMS? Sure! what could go wrong? - Antihero 15:48:49 08/28/14 hahahahahahaha! - BlackholeZ 22:01:03 08/26/14 Re: hahahahahahaha! - agent4573 11:42:35 08/27/14
Post a Followup	You cannot reply to this message because you are not logged in.