Subject	so with all lines replaced but still on oem solenoids what
Posted by	LivinTheDream on August 20, 2014 at 1:17 PM
	This message has been viewed 209 times.
In Reply To	That must have been a really old post you got that posted by Ash's Z on August 19, 2014 at 12:31 PM
Message	Should i expect?. On my previous build i saw about 12psi with i believe all the factory lines swapped for new rubber hose. This current build is not tested but im using silicone vacuum hose 6mm. I may have 3.5mm from the solenoids to the turbo inlet pipes. "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	What have I done! - JMartz 12:12:05 08/19/14 Pretty sure you're fine... - ThisIsSparTTa 12:17:28 08/19/14 Yes, we do have an EBC - BlackholeZ 12:30:42 08/19/14 That must have been a really old post you got that - Ash's Z 12:31:39 08/19/14 ^Yeah - -Grimm- 12:49:09 08/19/14 Spot-on, except it is an NC solenoid. :) - Ash's Z 13:13:10 08/19/14 Hey that's a good idea - BlackholeZ 14:57:35 08/19/14 Well, you would have to connect the OEM boost solenoid - Ash's Z 17:08:50 08/19/14 Which is what I did - -Grimm- 13:33:22 08/20/14 Several of the solenoids are mechanically switchable - Ash's Z 15:30:38 08/20/14 I am glad you have reviewed your position on this - JMartz 14:03:33 08/19/14 so with all lines replaced but still on oem solenoids what - LivinTheDream 13:17:38 08/20/14 You should expect issues - -Grimm- 13:43:00 08/20/14
Post a Followup	You cannot reply to this message because you are not logged in.