Subject	Well, you would have to connect the OEM boost solenoid
Posted by	Ash's Z on August 19, 2014 at 5:08 PM
	This message has been viewed 228 times.
In Reply To	Hey that's a good idea posted by BlackholeZ on August 19, 2014 at 02:57 PM
Message	line to a relay that connects/interrupts the signal from the controller to the solenoid. You wouldn't want to use the OEM boost solenoid wire as ground to your controller, the controller would be turning off and on all time.. off when you weren't in boost and turning on around 6psi, which is where the OEM system opens up the boost solenoid for higher boost. Enthusiasts soon understand each other. --W. Irving. Are you an enthusiast? If you are out to describe the truth, leave elegance to the tailor. Albert Einstein
Follow Ups	What have I done! - JMartz 12:12:05 08/19/14 Pretty sure you're fine... - ThisIsSparTTa 12:17:28 08/19/14 Yes, we do have an EBC - BlackholeZ 12:30:42 08/19/14 That must have been a really old post you got that - Ash's Z 12:31:39 08/19/14 ^Yeah - -Grimm- 12:49:09 08/19/14 Spot-on, except it is an NC solenoid. :) - Ash's Z 13:13:10 08/19/14 Hey that's a good idea - BlackholeZ 14:57:35 08/19/14 Well, you would have to connect the OEM boost solenoid - Ash's Z 17:08:50 08/19/14 Which is what I did - -Grimm- 13:33:22 08/20/14 Several of the solenoids are mechanically switchable - Ash's Z 15:30:38 08/20/14 I am glad you have reviewed your position on this - JMartz 14:03:33 08/19/14 so with all lines replaced but still on oem solenoids what - LivinTheDream 13:17:38 08/20/14 You should expect issues - -Grimm- 13:43:00 08/20/14
Post a Followup	You cannot reply to this message because you are not logged in.