Subject	I did do some grinding but...
Posted by	wickdGSXR on August 13, 2014 at 1:04 AM
	This message has been viewed 289 times.
In Reply To	My recommendation is to posted by Boosted1 on August 10, 2014 at 07:27 PM
Message	I did this to move the pipe that feed the TB's as close to the engine bay as possible. I could not get the oversized radiator in otherwise. Also, did you have to grind the ducts? Those side markers don't want to fit...even if I push the intercooler back.
Follow Ups	AshSpec planar intake and SMIC piping - wickdGSXR 12:18:15 08/10/14 Here is a link to me asking the same question. - Evan(CA) 12:34:46 08/10/14 I used the pics off of the ashspecz website. (n/m) - ZaXxon 13:19:17 08/10/14 Hi Chuck! Here's the .pdf version of the installation. =) - Ash's Z 13:34:28 08/10/14 thanks (n/m) - wickdGSXR 16:54:57 08/10/14 I'm surprised these kits don't have numbers etched onto - LJZTT 16:58:52 08/10/14 Even a sharpie writing on the edge of the pipe would help. (n/m) - ZXRider 01:29:41 08/11/14 Yes, that would be helpful. (n/m) - MixManMash 15:08:35 08/11/14 drivers side? - wickdGSXR 17:04:51 08/10/14 My recommendation is to - Boosted1 19:27:29 08/10/14 I did do some grinding but... - wickdGSXR 01:04:17 08/13/14 btw, this is the PERFECT time to clean your engine bay (n/m) - PiotrC70 23:44:19 08/10/14
Post a Followup	You cannot reply to this message because you are not logged in.