Subject	AshSpec planar intake and SMIC piping
Posted by	wickdGSXR on August 10, 2014 at 12:18 PM
	This message has been viewed 2258 times.
Message	Does anyone have directions or photos of this? I received a box of parts without any documentation. The photos below are my "best guess" based on SZ's website. I've emailed Ash's website last week and did not receive a response. From misc Planar intake seems a bit short. I assume it goes under the headlights like the stock ones? From misc There were two pipes almost identical that could be used for the intake side. Only difference was a few inches in length. From misc pressurized side coming out of turbos. I assume the bungs are for the wastegates. The two short pipes could need to be moved to intake side of SMIC's. From misc
Follow Ups	AshSpec planar intake and SMIC piping - wickdGSXR 12:18:15 08/10/14 Here is a link to me asking the same question. - Evan(CA) 12:34:46 08/10/14 I used the pics off of the ashspecz website. (n/m) - ZaXxon 13:19:17 08/10/14 Hi Chuck! Here's the .pdf version of the installation. =) - Ash's Z 13:34:28 08/10/14 thanks (n/m) - wickdGSXR 16:54:57 08/10/14 I'm surprised these kits don't have numbers etched onto - LJZTT 16:58:52 08/10/14 Even a sharpie writing on the edge of the pipe would help. (n/m) - ZXRider 01:29:41 08/11/14 Yes, that would be helpful. (n/m) - MixManMash 15:08:35 08/11/14 drivers side? - wickdGSXR 17:04:51 08/10/14 My recommendation is to - Boosted1 19:27:29 08/10/14 I did do some grinding but... - wickdGSXR 01:04:17 08/13/14 btw, this is the PERFECT time to clean your engine bay (n/m) - PiotrC70 23:44:19 08/10/14
Post a Followup	You cannot reply to this message because you are not logged in.