TwinTurbo.NET: Nissan 300ZX forum - No alignment necessary
People Seeking Info
 
   


     
Subject No alignment necessary
     
Posted by BOOZTD 3 on July 28, 2014 at 5:35 PM
  This message has been viewed 455 times.
     
In Reply To Re: Is that really less work than just pulling the motor? posted by ThisIsSparTTa on July 28, 2014 at 02:56 PM
     
Message The procedure is not that bad

Remove the front wheels
Pop the tie rods
Pull the tension rods
Pull the 17mm bolt/nut for the lower arm > subframe
Remove the engine mount nuts
Disconnect the two power steering lines
Mark the steering shaft, remove the bolt
Support the engine
Support the subframe
Remove the 4 nuts holding the subframe on, lower it
Pull the trans > engine brackets
Slide the soft oil return tubes up onto the hard tubes
Pull the oil cooler line
Drop the pan

I think I had 5 hours total and some of that was the intensive prep in those hard to reach areas for the new RTV

Def couldnt do an engine R&R + this repair in 5 hours












     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.