Subject	You're going to scrape
Posted by	BlackholeZ on June 27, 2014 at 11:09 PM
	This message has been viewed 213 times.
In Reply To	3" & 2.5" Labree/SZ exhaust ground clearance posted by ryzan on June 27, 2014 at 03:42 AM
Message	The exhaust is the lowest part of the car. I'm only dropped ~2" and I scrape speed bumps and driveways constantly. The only way to minimize damage is to have someone weld a plate basically armoring the areas that scrape the most. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	3" & 2.5" Labree/SZ exhaust ground clearance - ryzan 03:42:24 06/27/14 my 3" SZ setup goes below the rails :( (n/m) - JaffaUK 04:23:04 06/27/14 Yeah my 3" setup is pretty low too (n/m) - Drk93TT 07:21:51 06/27/14 3" dips low. i have flat spots now :( - SuparexTT 19:31:13 07/01/14 +3 (n/m) - Zsgetyoulaid 10:16:30 06/27/14 i bought a set of used 3" test pipes that were damaged - SammybTT(TN) 17:00:08 06/27/14 A not so good picture - SammybTT(TN) 21:19:24 06/27/14 Re: A not so good picture - ryzan 23:33:42 06/27/14 this is a 3" side profile. ground to fender is about 26.25" - SuparexTT 19:33:57 07/01/14 You're going to scrape - BlackholeZ 23:09:56 06/27/14
Post a Followup	You cannot reply to this message because you are not logged in.