Subject	Only the full face feramic have welded
Posted by	Joe@ZSpeedperformance on May 09, 2014 at 2:47 PM
	This message has been viewed 221 times.
In Reply To	I'm personally not a fan of Southbend clutches. posted by MixManMash on May 08, 2014 at 11:59 AM
Message	I have yet to see a feramic puck weld out of MANY that have been sold and are still in use 10 years later. Any clutch can weld if it gets hot enough.
Follow Ups	clutch recomnemdations to hold over 500hp rwhp - GitNMyBelly 21:50:15 05/07/14 RPS high five is the Swiss Army knife of Z clutches - 280ZuL8r 22:48:31 05/07/14 Re: RPS high five is the Swiss Army knife of Z clutches - GitNMyBelly 09:07:25 05/08/14 Re: Re: RPS high five is the Swiss Army knife of Z clutches - dTb 21:07:34 05/08/14 easier to launch - aliaZ 06:04:02 05/09/14 Talk to SZ. I am running a SZ Max Street with the SZ - MixManMash 06:28:19 05/08/14 Re: Talk to SZ. I am running a SZ Max Street with the SZ - GitNMyBelly 09:10:06 05/08/14 I'm personally not a fan of Southbend clutches. - MixManMash 11:59:08 05/08/14 Only the full face feramic have welded - Joe@ZSpeedperformance 14:47:10 05/09/14 only if you have slicks though. The high 5 likes to be - Attridge_300ZX 22:58:47 05/08/14 My SouthBend Stage 3 Endurance can handle 600 torque - Aqualung 10:30:05 05/08/14 Re: clutch recomnemdations to hold over 500hp rwhp - FlawleZ (San Antonio) 14:02:10 05/08/14
Post a Followup	You cannot reply to this message because you are not logged in.