| Message |
If you're installing the new BDE Bullseye cam gears... make sure you read the instructions :P Do not align the OEM dimple on the cog to the timing back plate mark Align the Zero mark tooth with the white line to the back plate dimple. If you look at the notch where the cam pin aligns the gear, you'll see it aligns to the Zero mark on the new cam gear, and not the factory dimple: 
This is different from installing Nissan OEM cam gears and first gen BDE gears. Brett does include this instruction on the paper in the box.... of course we didn't read it... Maybe Brett you could put a sticker on the gear that says not to align the OEM dimple. No damage done, no interference found on crank rotation and the car wouldn't fire. Pulled timing belt and corrected.... all good now. We got lucky.
  
MY Zs ARE HYBRID VEHICLES, THEY RUN ON
GASOLINE AND MONEY
"I expressed no attitude, I'm correcting you. If you don't
like it, try not to be wrong next time. Now you're getting
attitude, and if you don't like that you should grow a thicker
skin.”
- TriniTT 14:04:16 12/22/12
”Exhaust doesn't produce horsepower”
- VERTTZ 13:17:22 06/26/12
I'm off to wax mine and go for a drive now.
- BigTDogg (MA) 07:17:08 07/17/09 times
change, people change, but the Z32 still kicks ass.
- apudapus 16:46:02 06/15/07I was more
wondering how you set your climate control to 22* lol, it
would be that fastest freezer on wheels!
- Briscoe'sZ32 (NJ) 23:15:44
02/05/07You have *got* to be getting a cut from
B&B :D
- SeedyROM 15:24:29 08/16/06
What do you think B&B stands for?
- YugoBernie (NoVA) 15:57:09
08/16/06
|
 |
PSA: BDE Cam Gear Installation - 
