Subject	agreed
Posted by	aliaZ on April 25, 2014 at 1:29 PM
	This message has been viewed 162 times.
In Reply To	that, and ensure your pilot bushing is absolutely centered posted by vorpalZ on April 25, 2014 at 09:06 AM
Message	I had my machine shop at work make a pilot tool out of aluminum round stock. I also use it as a pilot bushing removal tool. Pack the bushing with grease, insert tool, couple of hits with a hammer and the bushing is pushed out
Follow Ups	Finally Started NA>TT Swap! - tribalchild1 15:18:52 04/24/14 it only takes me an extra 15 minutes to remove the tranny - fuzzymonkey 17:01:03 04/24/14 It's stabbing the trans again afterwards that's the problem. (n/m) - my91z 19:41:29 04/24/14 Gotta learn how to 'stick it' in there kiddo. (n/m) - LivinTheDream 19:49:05 04/24/14 Re: Gotta learn how to 'stick it' in there kiddo. - Huber300zx 20:38:08 04/24/14 Sup. (n/m) - PennStateZ (NoVA) 22:08:44 04/24/14 Sup (n/m) - ZXRider 00:14:10 04/25/14 Still have a TT eh? (n/m) - PennStateZ (NoVA) 08:30:26 04/25/14 Yes sir. A big pain in my you know what, but still have it - ZXRider 13:55:37 04/25/14 2011 I think... - PennStateZ (NoVA) 12:42:27 04/26/14 Hey. (n/m) - my91z 12:59:39 04/26/14 Use the "bold with head cut off technique" - spicyZ 08:34:05 04/25/14 that, and ensure your pilot bushing is absolutely centered - vorpalZ 09:06:21 04/25/14 You mean clutch disc is absolutely centered. (n/m) - MixManMash 09:37:52 04/25/14 ... yes, and make sure you HAVE a pilot bushing :) (n/m) - vorpalZ 09:45:12 04/25/14 lol. Amazing how easy it is to stab the trans in without - MixManMash 12:15:01 04/25/14 I've used the plastic alignment tool dozens of times - BlackholeZ 13:25:20 04/25/14 agreed - aliaZ 13:29:32 04/25/14 Tried that with no joy. W/trans jack and w/o >> - my91z 06:52:31 04/26/14 Re: Finally Started NA>TT Swap! - sdvdoc 22:40:21 04/24/14 update on the tow loops for pulling motor. - tribalchild1 15:44:43 04/25/14
Post a Followup	You cannot reply to this message because you are not logged in.