Subject	mounting of rear spoiler questions.
Posted by	Coldfusown on April 21, 2014 at 1:02 PM
	This message has been viewed 374 times.
Message	Hello guys. When I purchased my Z the rear spoiler was lifting a bit. It's an aftermarket replica mounted by previous owner. I have been having water in the trunk area which prompted the removal. The entire wing was adhered with a tar like substance and no screws or bolts were used. I am having it painted and wish to mount it properly. How do I waterproof the area that my wiring passes through, a large hole in the trunk hatch. I intend to use screws in the four holes provided wing side but what else? A seal of sorts or just gasket maker around the underside? Thanks.
Follow Ups	mounting of rear spoiler questions. - Coldfusown 13:02:58 04/21/14 Here is a picture. - Coldfusown 13:08:01 04/21/14 You can use either 3M double sided tape or Sikaflex - CmyZ 21:50:08 04/21/14 Thank you! (n/m) - Coldfusown 15:42:01 04/23/14
Post a Followup	You cannot reply to this message because you are not logged in.