Subject	X2 - Sometimes I've been without a comp tester
Posted by	BOOZTD 3 on April 20, 2014 at 9:08 PM
	This message has been viewed 277 times.
In Reply To	It's not the bearings that I would be worried about, posted by Machtavian on April 20, 2014 at 07:44 PM
Message	If you have a long screwdriver you can set it on top of the piston and measure the travel while rotating the engine over by hand. It will be pretty visible which one is short. I have had a few engines come in with a botched fuel injector install that had bent rods, its about as common as a water induced hydrolock these days. Good luck Dee
Follow Ups	I guess its not a good idea to turn a motor over with - The Devils Z 18:34:47 04/20/14 It's not the bearings that I would be worried about, - Machtavian 19:44:20 04/20/14 engine never turned a full revolution ..i'm hoping rods - The Devils Z 20:28:45 04/20/14 X2 - Sometimes I've been without a comp tester - BOOZTD 3 21:08:20 04/20/14 *Keeping fingers crossed* Best of luck. (n/m) - OverZealous (CT) 20:36:38 04/20/14 We have the O-rings (n/m) - Russell@Z1 21:34:11 04/20/14 thanks -- talked to John -- evidently this is called - The Devils Z 09:46:42 04/21/14 Huh? (n/m) - Bernie (NoVA) 23:43:58 04/21/14 eh...somebody is confused (n/m) - aliaZ 06:20:27 04/22/14 Yep -- wiki says you are correct ... - The Devils Z 12:42:44 04/22/14 Holy crap man! Good luck with that! (n/m) - ConVerTT 22:19:54 04/20/14 Oh shit dude....not good.. - eriksu9 10:10:24 04/21/14 been there before! - JaffaUK 13:10:18 04/21/14
Post a Followup	You cannot reply to this message because you are not logged in.