Subject	It's not the bearings that I would be worried about,
Posted by	Machtavian on April 20, 2014 at 7:44 PM
	This message has been viewed 254 times.
In Reply To	I guess its not a good idea to turn a motor over with posted by The Devils Z on April 20, 2014 at 06:34 PM
Message	but rather the rods being bent. Easiest way to check if you have a bent rod is to do a compression check. Keep your fingers crossed!
Follow Ups	I guess its not a good idea to turn a motor over with - The Devils Z 18:34:47 04/20/14 It's not the bearings that I would be worried about, - Machtavian 19:44:20 04/20/14 engine never turned a full revolution ..i'm hoping rods - The Devils Z 20:28:45 04/20/14 X2 - Sometimes I've been without a comp tester - BOOZTD 3 21:08:20 04/20/14 *Keeping fingers crossed* Best of luck. (n/m) - OverZealous (CT) 20:36:38 04/20/14 We have the O-rings (n/m) - Russell@Z1 21:34:11 04/20/14 thanks -- talked to John -- evidently this is called - The Devils Z 09:46:42 04/21/14 Huh? (n/m) - Bernie (NoVA) 23:43:58 04/21/14 eh...somebody is confused (n/m) - aliaZ 06:20:27 04/22/14 Yep -- wiki says you are correct ... - The Devils Z 12:42:44 04/22/14 Holy crap man! Good luck with that! (n/m) - ConVerTT 22:19:54 04/20/14 Oh shit dude....not good.. - eriksu9 10:10:24 04/21/14 been there before! - JaffaUK 13:10:18 04/21/14
Post a Followup	You cannot reply to this message because you are not logged in.