Subject	Matches my EVC III's stepper motor/pressure sensor asmbly.
Posted by	SeanK (StL) on April 13, 2014 at 2:41 PM
	This message has been viewed 172 times.
In Reply To	HKS EVC 3, 4 or ez i think. (n/m) posted by Antihero on April 12, 2014 at 02:24 PM
Message	I believe the HKS EVC IV used the same motor/sensor assembly with a different harness plug to a revised head unit.
Follow Ups	Name This EBC - Khronik 10:53:41 04/12/14 I think it goes to an early version HKS EVC (n/m) - The Devils Z 11:21:32 04/12/14 any chance its possible to buy just the controller unit? (n/m) - Khronik 11:25:59 04/12/14 Not really any reason to use something that dated (n/m) - Bernie (NoVA) 11:51:23 04/12/14 I have an evc3 control unit I can sell you (n/m) - KongZTT GT28RS MD 12:27:23 04/12/14 would that work with this solenoid? (n/m) - Khronik 14:22:01 04/12/14 They were encoder valves, not solenoids. - puchy 19:01:20 04/12/14 eBay might be a good start. (n/m) - SeanK (StL) 14:51:54 04/13/14 my old gen1 EVC valve box was not square like this one (n/m) - shaggee 13:00:26 04/12/14 Looks like evc ez, the controller and valve are paired. - puchy 12:22:46 04/12/14 Either for an hks evc or afc. If you look on the back - TTZ2NV(EPTmotorsports) 12:34:35 04/12/14 only issue is that sticker was partly destroyed - Khronik 14:19:38 04/12/14 HKS EVC 3, 4 or ez i think. (n/m) - Antihero 14:24:38 04/12/14 looking at the pics im guessing it is the EZ - Khronik 14:30:05 04/12/14 Matches my EVC III's stepper motor/pressure sensor asmbly. - SeanK (StL) 14:41:54 04/13/14 Dennis (n/m) - zgene4 22:05:32 04/12/14 I was always partial to the classic 'George'. (n/m) - SeanK (StL) 15:01:28 04/13/14
Post a Followup	You cannot reply to this message because you are not logged in.