Subject	Do some 60-0, 80-0, 100-0 tests if possible and get temps
Posted by	SMAZ (OKC) on October 28, 2013 at 8:51 PM
	This message has been viewed 157 times.
In Reply To	Finished building my brakes and figured I would share. posted by 5280Z_nightstalker on October 28, 2013 at 03:17 PM
Message	I have the 350Z front with RP bracket in the rear with Powerstop slotted rotors. At the last track day I measured my calipers at 270 degrees and rotors ~560 F in front. My buddy with his 370Z and AP racing calipers with 2 piece rotors was half that in temps. I was actually pretty amazed at the difference. Speeds were 90 mph tops with short hard braking, but nothing extreme. 1996 TT #61 of 300
Follow Ups	Finished building my brakes and figured I would share. - 5280Z_nightstalker 15:17:15 10/28/13 Looks great. Is this the Arizona Z Car kit? (n/m) - ZXRider 15:32:44 10/28/13 No, all custom. Measured and built the brackets with some - 5280Z_nightstalker 19:39:38 10/28/13 did you just happen to have some 370Z rotors on hand? - LJZTT 22:45:35 10/28/13 Ya I was going to go with the Akebono then I liked the idea - 5280Z_nightstalker 02:22:12 10/29/13 looks good and classy - fuzzymonkey 15:50:05 10/28/13 looks good, what did that setup run you? (n/m) - CWRaab(philly) 17:43:22 10/28/13 Do some 60-0, 80-0, 100-0 tests if possible and get temps - SMAZ (OKC) 20:51:59 10/28/13 looks great, but will get rusty quick. - Antihero 13:47:07 10/29/13
Post a Followup	You cannot reply to this message because you are not logged in.