TwinTurbo.NET: Nissan 300ZX forum - The block is fine
People Seeking Info
 
   


     
Subject The block is fine
     
Posted by Broke_as_**** on September 10, 2013 at 8:43 PM
  This message has been viewed 222 times.
     
In Reply To From your pictures it looks like its the block casting posted by Inzane on September 10, 2013 at 02:24 PM
     
Message That little bit of angle isn't going to hurt the oil line and there is room behind the fitting, it's just the angle of the picture. The problem is the AC bracket casting that's molded for just enough clearance around the banjo bolt. The flex line is thicker in that area than the stock hard line so there is just enough contact to break the banjo fitting.


     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.