Subject	You can remove AC comp. and then bracket and take a look
Posted by	Bernie (NoVA) on September 10, 2013 at 2:33 PM
	This message has been viewed 222 times.
In Reply To	I removed/grind the excess material from the AC bracket posted by ZXRider on September 10, 2013 at 01:28 PM
Message	without pulling the motor. Bernie Bilski berniebilski@cox.net 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red ZCCNV #390 ~ ECZA #368
Follow Ups	First start! Finally.....Oil leak... - Black95 21:35:18 09/09/13 Been there twice. - MixManMash 21:59:56 09/09/13 Re: Been there twice. - BOOZTD 3 23:56:23 09/09/13 Got to pull the AC pump and remove the bracket (n/m) - vorpalZ 22:34:13 09/09/13 Re: Got to pull the AC pump and remove the bracket - wild_maxx 05:25:09 09/10/13 Either the line is not threaded in all the way into the - MixManMash 06:30:20 09/10/13 Or if its a flex line you tweeked the fitting and you need - Bernie (NoVA) 09:04:07 09/10/13 Never experienced that... Definitely would suck. (n/m) - MixManMash 10:14:03 09/10/13 How would one tweeked the fitting? - ZXRider 10:49:18 09/10/13 If you don't grind the AC bracket you can cause issues. - Woody75 (Denver) 11:42:19 09/10/13 Oh right! Forgot that you need to grind the bracket to make - MixManMash 13:14:18 09/10/13 I removed/grind the excess material from the AC bracket - ZXRider 13:28:39 09/10/13 You can remove AC comp. and then bracket and take a look - Bernie (NoVA) 14:33:12 09/10/13 2 Questions - ZXRider 15:11:00 09/10/13 2 Answers. - MixManMash 15:31:47 09/10/13 Please describe how I could have tweaked the fitting and - Black95 10:58:39 09/10/13 Didn't remove enough material from the AC bracket or - Bernie (NoVA) 12:17:46 09/10/13 Hmmm. I didnt remove any material from the bracket and - Black95 12:46:01 09/10/13 Definetly the banjo bolt. I even tried snugging it up... - Black95 12:55:54 09/10/13 Are you using flex lines? If so its likely damaged and - Bernie (NoVA) 14:31:05 09/10/13 Thanks Bernie... - Black95 15:56:16 09/10/13 From your pictures it looks like its the block casting - Inzane 14:24:39 09/10/13 The block is fine - Broke_as_**** 20:43:33 09/10/13 Thanks Stan. Your explanation definitely clears it up for - Inzane 10:28:24 09/11/13 Re: First start! Finally.....Oil leak... - -Grimm- 13:14:44 09/10/13
Post a Followup	You cannot reply to this message because you are not logged in.