Subject	Been there twice.
Posted by	MixManMash on September 09, 2013 at 9:59 PM
	This message has been viewed 265 times.
In Reply To	First start! Finally.....Oil leak... posted by Black95 on September 09, 2013 at 09:35 PM
Message	Pull the radiator to give you more space to pull the compressor forward, undo the compressor (I hope you didn't put that bitch back bolt on, otherwise you have to raise the engine). Move it up and out of the way towards the front. Use wire to tie it up. Get out your long extensions and universal joint to remove the AC compressor bracket from the engine block. In reference to the banjo bolt, make sure that the bolt is tight, but also the line that goes into the banjo fitting is threaded in properly and tight as it can also leak there. Reassembly is still the same process.
Follow Ups	First start! Finally.....Oil leak... - Black95 21:35:18 09/09/13 Been there twice. - MixManMash 21:59:56 09/09/13 Re: Been there twice. - BOOZTD 3 23:56:23 09/09/13 Got to pull the AC pump and remove the bracket (n/m) - vorpalZ 22:34:13 09/09/13 Re: Got to pull the AC pump and remove the bracket - wild_maxx 05:25:09 09/10/13 Either the line is not threaded in all the way into the - MixManMash 06:30:20 09/10/13 Or if its a flex line you tweeked the fitting and you need - Bernie (NoVA) 09:04:07 09/10/13 Never experienced that... Definitely would suck. (n/m) - MixManMash 10:14:03 09/10/13 How would one tweeked the fitting? - ZXRider 10:49:18 09/10/13 If you don't grind the AC bracket you can cause issues. - Woody75 (Denver) 11:42:19 09/10/13 Oh right! Forgot that you need to grind the bracket to make - MixManMash 13:14:18 09/10/13 I removed/grind the excess material from the AC bracket - ZXRider 13:28:39 09/10/13 You can remove AC comp. and then bracket and take a look - Bernie (NoVA) 14:33:12 09/10/13 2 Questions - ZXRider 15:11:00 09/10/13 2 Answers. - MixManMash 15:31:47 09/10/13 Please describe how I could have tweaked the fitting and - Black95 10:58:39 09/10/13 Didn't remove enough material from the AC bracket or - Bernie (NoVA) 12:17:46 09/10/13 Hmmm. I didnt remove any material from the bracket and - Black95 12:46:01 09/10/13 Definetly the banjo bolt. I even tried snugging it up... - Black95 12:55:54 09/10/13 Are you using flex lines? If so its likely damaged and - Bernie (NoVA) 14:31:05 09/10/13 Thanks Bernie... - Black95 15:56:16 09/10/13 From your pictures it looks like its the block casting - Inzane 14:24:39 09/10/13 The block is fine - Broke_as_**** 20:43:33 09/10/13 Thanks Stan. Your explanation definitely clears it up for - Inzane 10:28:24 09/11/13 Re: First start! Finally.....Oil leak... - -Grimm- 13:14:44 09/10/13
Post a Followup	You cannot reply to this message because you are not logged in.