Subject	Re: Nice writeup Mitch! If you are targeting a price point,
Posted by	Tech@EPR on May 18, 2013 at 12:04 PM
	This message has been viewed 487 times.
In Reply To	Nice writeup Mitch! If you are targeting a price point, posted by TriniTT on May 18, 2013 at 07:56 AM
Message	Rightfully so but the scenario of "buy the most expensive" doesn't lend itself to offering you the best product. Probe pistons for example I'd pick over Wiseco and when they were available were only $350 for a set. You still had to get your own rings made by companies like Total Seal but the piston itself was extremely capable of handling excessive amounts of abuse. Ep Racing | Create Your Badge
Follow Ups	VG30 Forged Piston Comparison - Tech@EPR 16:52:27 05/17/13 Nice write up... VFAQ (n/m) - Zski (NoVA) 17:04:54 05/17/13 Good info. Have to agree with you on the cp's. I am - ztunerz 17:07:24 05/17/13 Re: VG30 Forged Piston Comparison - miloz 19:51:09 05/17/13 Left Justified - FuerGrissa 21:24:32 05/17/13 What about the noise from CP pistons.. that clatter .. - My300zx 21:35:00 05/17/13 Re: What about the noise from CP pistons.. that clatter .. - Tech@EPR 21:40:11 05/17/13 That would imply that there is a lot of blocks out of specs - My300zx 01:00:09 05/18/13 Re: That would imply that there is a lot of blocks out of specs - Tech@EPR 01:29:35 05/18/13 While I agree that improper shop practices are the - aliaZ 07:48:10 05/18/13 Re: While I agree that improper shop practices are the - Tech@EPR 12:00:02 05/18/13 Yes they are zero offset (n/m) - ztunerz 17:58:16 05/18/13 Nice writeup Mitch! If you are targeting a price point, - TriniTT 07:56:16 05/18/13 Re: Nice writeup Mitch! If you are targeting a price point, - Tech@EPR 12:04:17 05/18/13 Not to thread-jack, but both forgings seem to be so... 1980s - LitlElvis 10:39:41 05/18/13 Re: Not to thread-jack, but both forgings seem to be so... 1980s - Tech@EPR 12:02:03 05/18/13 Would you apply some coating on those pistons (ceramic...) ? (n/m) - Dark Diver 11:29:16 05/18/13 Re: Would you apply some coating on those pistons (ceramic...) ? - Tech@EPR 12:06:38 05/18/13
Post a Followup	You cannot reply to this message because you are not logged in.