Subject	Re: What about the noise from CP pistons.. that clatter ..
Posted by	Tech@EPR on May 17, 2013 at 9:40 PM
	This message has been viewed 656 times.
In Reply To	What about the noise from CP pistons.. that clatter .. posted by My300zx on May 17, 2013 at 09:35 PM
Message	Block then isn't machined properly. Your cylinder bores are inconsistent with taper and concentricity run out. Ep Racing | Create Your Badge
Follow Ups	VG30 Forged Piston Comparison - Tech@EPR 16:52:27 05/17/13 Nice write up... VFAQ (n/m) - Zski (NoVA) 17:04:54 05/17/13 Good info. Have to agree with you on the cp's. I am - ztunerz 17:07:24 05/17/13 Re: VG30 Forged Piston Comparison - miloz 19:51:09 05/17/13 Left Justified - FuerGrissa 21:24:32 05/17/13 What about the noise from CP pistons.. that clatter .. - My300zx 21:35:00 05/17/13 Re: What about the noise from CP pistons.. that clatter .. - Tech@EPR 21:40:11 05/17/13 That would imply that there is a lot of blocks out of specs - My300zx 01:00:09 05/18/13 Re: That would imply that there is a lot of blocks out of specs - Tech@EPR 01:29:35 05/18/13 While I agree that improper shop practices are the - aliaZ 07:48:10 05/18/13 Re: While I agree that improper shop practices are the - Tech@EPR 12:00:02 05/18/13 Yes they are zero offset (n/m) - ztunerz 17:58:16 05/18/13 Nice writeup Mitch! If you are targeting a price point, - TriniTT 07:56:16 05/18/13 Re: Nice writeup Mitch! If you are targeting a price point, - Tech@EPR 12:04:17 05/18/13 Not to thread-jack, but both forgings seem to be so... 1980s - LitlElvis 10:39:41 05/18/13 Re: Not to thread-jack, but both forgings seem to be so... 1980s - Tech@EPR 12:02:03 05/18/13 Would you apply some coating on those pistons (ceramic...) ? (n/m) - Dark Diver 11:29:16 05/18/13 Re: Would you apply some coating on those pistons (ceramic...) ? - Tech@EPR 12:06:38 05/18/13
Post a Followup	You cannot reply to this message because you are not logged in.