Subject	Never had it happen to me, but I doubt it'll hurt anything (n/m)
Posted by	black300zx on April 24, 2013 at 9:24 PM
	This message has been viewed 212 times.
In Reply To	Bent Throttle Spring After Powdercoating... posted by Terayonneo on April 24, 2013 at 08:46 PM
Message
Follow Ups	Bent Throttle Spring After Powdercoating... - Terayonneo 20:46:19 04/24/13 Never had it happen to me, but I doubt it'll hurt anything (n/m) - black300zx 21:24:37 04/24/13 If it was straight, and moved in reaction to powdercoating, - zellamay 22:29:18 04/24/13 I installed it back on the throttle body and it doesn't seem - Terayonneo 10:52:40 04/25/13 I don't know throttle springs specifically, but you've - zellamay 12:17:20 04/25/13 Are you sure you installed it correctly? - FuerGrissa 13:04:07 04/25/13 I fixed it... - Terayonneo 16:58:33 04/25/13 Yeah, team. (n/m) - zellamay 18:07:48 04/25/13 shouldnt hurt anything (n/m) - Drk93TT 22:41:42 04/24/13 the heat from the oven didn't kill the springs? (n/m) - nemo1080 (Iowa) 14:26:13 04/25/13 Nope, powder coating the springs is perfectly fine. (n/m) - Terayonneo 17:01:32 04/25/13 It takes alot more that 350F to effect a steel spring (n/m) - black300zx 19:23:21 04/25/13 good to know. thanks. (n/m) - nemo1080 (Iowa) 19:28:45 04/25/13
Post a Followup	You cannot reply to this message because you are not logged in.