Subject	couldnt be difficult to cut off extra areas and weld plate
Posted by	fst300zx on April 06, 2013 at 7:41 AM
	This message has been viewed 138 times.
In Reply To	Can anyone explain our intake valve cover design? posted by AHos(Chicago) on April 05, 2013 at 02:44 PM
Message	might be nice to clean them up some>? ">
Follow Ups	Can anyone explain our intake valve cover design? - AHos(Chicago) 14:44:24 04/05/13 They were thinking ahead for the PCV reroute :) - Woody75 (Denver) 14:53:56 04/05/13 I was hoping you would chime in on this - AHos(Chicago) 15:29:38 04/05/13 People have done the plate method before. - Woody75 (Denver) 16:18:39 04/05/13 So it could hypothetically work - AHos(Chicago) 16:45:27 04/05/13 The 2 w the small holes are used for guiding coil pack wires - Bernie (NoVA) 16:54:51 04/05/13 Not sound stupid but what is that out of ? (n/m) - z32z 19:43:58 04/05/13 cima vg30det. would be interesting to see how the pcvs on - DarkZide 20:07:47 04/05/13 I wonder if it was to increase the internal air volume... - ZinnZ32 16:54:59 04/05/13 That is a good point. - AHos(Chicago) 18:37:09 04/05/13 couldnt be difficult to cut off extra areas and weld plate - fst300zx 07:41:29 04/06/13
Post a Followup	You cannot reply to this message because you are not logged in.