Subject	NO, spacing for ends are not right for the Z (n/m)
Posted by	MidLifeZ (DFW) on December 17, 2012 at 4:09 PM
	This message has been viewed 114 times.
In Reply To	Did you try to lift your Z with it? (n/m) posted by Spongerider :) on December 17, 2012 at 04:05 PM
Message
Follow Ups	Lift bars for Z32? - MidLifeZ (DFW) 15:51:19 12/17/12 Did you try to lift your Z with it? (n/m) - Spongerider :) 16:05:11 12/17/12 NO, spacing for ends are not right for the Z (n/m) - MidLifeZ (DFW) 16:09:56 12/17/12 Wow, I like that, but is it safe? (n/m) - pieboy100 18:04:03 12/17/12 Creative but.. - ali300zx 18:23:21 12/17/12 You would still use the same jack points, - MidLifeZ (DFW) 08:02:26 12/18/12 I see it being difficult to get under - Z1 ZONLY 08:39:54 12/18/12 I see no benefit. - Woody75 (Denver) 12:37:54 12/18/12 I agree. - nemo1080 (Iowa) 15:55:14 12/19/12 hell with the bars, tell us more about those magic stands (n/m) - LJZTT 16:17:49 12/18/12 I use these - aliaZ 09:29:42 12/19/12 So your rocker panel isn't dinged up or dented? I would have - *BK300ZX* 15:58:24 12/19/12
Post a Followup	You cannot reply to this message because you are not logged in.