Subject	details please?
Posted by	aliaZ on December 09, 2012 at 5:55 PM
	This message has been viewed 265 times.
In Reply To	Who soldered the two hot wires to the stock connection? posted by RZturbo on December 09, 2012 at 05:41 PM
Message	:Drill out the stock connections and put solvent resistant expansion nuts through. That's how I wired my dual walbro pumps with 8AWG wires. link to solvent resistant expansion nuts? I need to do the same. Thanks
Follow Ups	ash spec dual fuel pump controller issues/danger - DarkZide 14:41:31 12/09/12 What was Ash's feedback on the failure? (n/m) - samsung-Z [Houston] 14:50:13 12/09/12 well Ray the cars owner emailed him or Z1 - DarkZide 15:39:01 12/09/12 that could have potentially caused an explosion (n/m) - WhiTTe Z 16:11:18 12/09/12 that could have potentially caused an explosion (n/m) - WhiTTe Z 15:47:37 12/10/12 that could have potentially caused an explosion (n/m) - WhiTTe Z 16:56:46 12/11/12 If the wiring was the issue, curious why you didn't - Jayru 15:03:49 12/09/12 after discussing this with the guys at Spec Z we decided - DarkZide 15:42:00 12/09/12 I'm confused - Jayru 17:15:58 12/09/12 sorry for the confusion here is what I did - DarkZide 17:26:26 12/09/12 whoa (n/m) - LJZTT 15:05:52 12/09/12 You need to rewire with #10 wire, the existing wire can't - njz 15:44:57 12/09/12 it looks like the pigtails that came with the pumps - aliaZ 17:28:21 12/09/12 Who soldered the two hot wires to the stock connection? - RZturbo 17:41:53 12/09/12 details please? - aliaZ 17:55:25 12/09/12 Yeah thats how it was before, I change that set up as well - DarkZide 18:51:01 12/09/12 I forget exactly how I worked around this but I think I - The Devils Z 18:30:34 12/09/12 Yeah the way I have it only one pump runs at idle - DarkZide 19:08:58 12/09/12 Re: Yeah the way I have it only one pump runs at idle - WazTTed 05:17:22 12/10/12 Re: I forget exactly how I worked around this but I think I - ouikikazz 14:00:09 12/10/12 there is an unused pin on the ashspec controller - aliaZ 07:04:00 12/12/12 so why does ash not put this in his install instructions? (n/m) - DarkZide 11:37:06 12/12/12 good question - aliaZ 17:49:23 12/13/12 I think I just upgraded the ground wire and had no issues. (n/m) - toykoz32 12:19:22 12/11/12 Interested in doing a write up for us? (n/m) - KongZTT GT28RS MD 21:25:07 12/09/12 possibly, I would rather do a write up when I install the - DarkZide 21:56:00 12/09/12 sounds good man - KongZTT GT28RS MD 22:10:27 12/09/12
Post a Followup	You cannot reply to this message because you are not logged in.